10 Configure the alarm settings [Alarm]The settings relating to alarm occurrences such as settings for the alarm action at an alarm occurrence oralarm images, the VMD area settings, audio detection settings, and the alarm occurrence notification can beconfigured on this page.The “Alarm” page has the [Alarm] tab, the [VMD area] tab, the [Audio detection] tab, and the [Notification] tab.10.1 Configure the settings relating to the alarmaction [Alarm]Click the [Alarm] tab on the “Alarm” page. (®page 32, page 34)The settings relating to the camera action at an alarm occurrence can be configured in this section. Refer topage 101 for further information about the settings relating to the alarm images and the alarm output terminal.Alarm[Terminal 1]Determine how to use terminal 1.• Off: Not used.• Alarm input: Receives alarms. When “Alarm input” is selected, a pull-down menu for “Close” and“Open” is displayed.– Close: An alarm is detected when the terminal status is changed to “Close”.– Open: An alarm is detected when the terminal status is changed to “Open”.• Black & white input: Receives the black & white switchover input. (When the input is set to On, the black& white mode is activated.)• Auto time adjustment: Receives time & date setting from the terminal input. When a signal is inputted, ifthe time difference from the hour (the hour at "00" minutes) is 29 minutes or less, the time will be set to thehour and "00" minutes and "00" seconds. When the time setting is moved back by less than 5 seconds,the time is not changed.When “Auto time adjustment” is selected, a pull-down menu for “Close” and “Open” is displayed.– Close: An alarm is detected when the terminal status is changed to “Close”.– Open: An alarm is detected when the terminal status is changed to “Open”.• Default: OffOperating Instructions 9910 Configure the alarm settings [Alarm]
