[Status]The port forwarding status will be displayed.[Router global address]The global address of router will be displayed.Note• Refer to our website (http://security.panasonic.com/support/info/) for further information about thecontents of the displayed statuses (relating to the “Viewnetcam.com” service, the UPnP function, selfcheck, hardware information, or wiper counter).Self checkThe self check result of the hardware will be displayed. There are no problems if a number contains all 0’s.Hardware informationInformation about PAN, TILT, ZOOM, FOCUS, Day & Night(IR), reboot counter, operating time, andthermo-sensor will be displayed.Note• Hardware information is updated once every 2 hours.Wiper counter[Wiper motor counter]Displays the number of times that the wiper motor has been operated.[Wiper rubber]Displays information about the wiper rubber.• [Counter]Displays the number of times that the wiper rubber has been operated and the counter for the exchangeguideline.• [Latest exchange]Displays the date when the wiper rubber was last exchanged.• [Reset at exchange]When exchanging a wiper rubber, replaces the date for "Latest exchange" with the date when reset wasexecuted.Note• The wiper motor and wiper rubber counters are updated once every 2 hours.15.3.1 Damage notification functionThe settings relating to external notifications for hardware errors and wiper rubber exchange periods can beconfigured in this section.Damage notification function types• Hardware error notificationWhen there is a problem with the hardware, an external notification is sent with either “Hardware1” or“Hardware2” of “Self check” in the [Status] tab of the “Maintenance” page.186 Operating Instructions15 Maintenance of the camera [Maintenance]
