Parker HLR070 Mounting Instructions

Contents

Parker HLR070 Mounting Instructions Manual pdf 27 page image

Parker EME Installation / dismantelling of the drive192-510201N1 HLR 2019-04 273.5 Installation / dismantelling of the driveBefore mounting or dismantelling the motor, de-energize it.As standard, the HLR Linear actuators are equipped without drive flange. For thegear attachment, one of the optionally available flange kits is needed (seeaccessories in the HLR catalogue).For dismantelling, the assembling sequence has to be carried out in reverse order.Assembling sequenceFigure 5: Assembly of driveRequirement: Axis is mounted in the system or fastened to another basicstructure. Remove protection caps (see Figure 5, Pos. 1) of the respective side of thedeflection station. Push clamp collar (please refer to Figure 5, Pos. 2) incl. clamping screw (pleaserefer to Figure 5 Pos. 3 onto the pulley. The clamping surface between pulley andclamp collar must be free of oil and grease.Clamp collar must abut to the pulley shoulder. The slot in the clamp collar mustbe aligned to the slot in the pulley (see Figure 5 detailled view A). Adjust clamp collar (please refer to Figure 5, Pos. 2) and pulley. Manually pushcarriage so that the clamping screw (please refer to Figure 5, Pos. 3) isaccessible through the front mounting bore of the deflection station. Pre-assemble drive package (motor with gears). Please observe operatinginstructions/ manual of motor and gearbox. Clean drive shaft and drive flange from anti corrosion agents, grease and oil. Mount the HLR gear flange (see Figure 5, Pos. 4) to the gear output side usingthe gear screws (see Figure 5, Pos. 5). For screws please refer to Table 5.