Parker HLR070 Mounting Instructions

Contents

Parker HLR070 Mounting Instructions Manual pdf 29 page image

Parker EME Assembly of Z-axes192-510201N1 HLR 2019-04 293.6.1. Mounting ETH/ETT032 on single axis via bracket plateFigure 6: Mounting ETH/ETT032 via bracket plate The HLR linear axis must be mounted in the system according to these mountinginstructions (see chapter mounting of an individual axis (see page 21)). Remove both centering sleeves on the carriage of the linear actuator (pleaserefer to Figure 6: Pos. 5).Carriage and bracket plate must be clean and free of grease. Position the bracket plate so that the longitudinal grooves of the bracket plate areabove the mounting threads in the carriage. Depending on the size of the linearaxis, either the outer or inner longitudinal grooves should be used. Fix the bracket plate with the screws supplied (see Figure 6: Pos. 1) on thecarriage. Position screws only slightly. Adjust the desired excess of the bracket plate to the linear axis and crosswisetighten the screws (see Figure 6: Pos. 1) to the respective tightening torque (seeTable 6).For the following steps the ETH cylinder with attached motor/gear must bepresent If this is not the case, mount the motor/gear package according to theETH assembly instructions.When using the ETH cylinder with parallel guide, first remove the parallel guidefrom the cylinder.Secure the Z-axis + motor / gear against tilting or falling during the assemblyprocess. Place the ETH/ETT cylinder on the cantilever plate in the centering boreprovided. Fix the ETH/ETT cylinder crosswise with the screws supplied (see Figure 6: Pos.4)and the required tightening torque (see Table 6).When using the ETH cylinder with parallel guide, first place the parallel guide atthe bottom of the outrigger plate and fix the entire unit with the screws supplied.