Parker SciLog FilterTec Plus Installation, Operation & Maintenance Instructions Manual

Contents

Parker SciLog FilterTec Plus Installation, Operation & Maintenance Instructions Manual Manual pdf 56 page image

566.0 Manual:Summary: In the Manual Mode the FilterTec Plus pump can be manually operated. The pumpspeed can be set by pressing the “Rate” key. The pump will also display the pressure indicatedon SciPres sensor P1.NOTE: The CONSTANT RATE and CONSTANT PRESSURE parameters, including thealarms, cannot be accessed in the Manual Mode.When in CONSTANT RATE or CONSTANT PRESSURE operational modes, the pump speedand/or pressure can be adjusted in terms of % motor speed while the pump is running. Justpress the “RATE” key, make the appropriate adjustment, and press “SELECT”.7.0 Data Acquisition:Summary: Parker has available a software package called SciDoc that includes data collectionsoftware and a Custom Excel spreadsheet that is automatically populated when any of themodes are executed except Manual. It also has charts that are automatically populated as thedata is generated. See Section 7.1 below.Either the Printer Port or USB Port may be used for data collection. The instructions forinstalling the USB driver appear at the beginning of this manual. The FilterTec Plus Printer Portis required for use with a serial printer, and both Thermal and Dot Matrix are available. By usingboth ports, the data can be simultaneously captured on a PC and a Printer.When a PC is connected, all data generated in RATE, PRESSURE, and STEP-SCAN modescan be sent to the PC for archiving. Please use the Parker SciDoc Data Collection Softwaredescribed below. Alternatively, a PC running “HyperTerminal”, a program that comes withWindows, may be used to capture the data. The HyperTerminal settings are provided for you insection 7.2 entitled “PC HyperTerminal Settings.” When interfacing with a PC you will need aseparate RS-232 cable (P/N: 080-073) or USB cable (P/N: 090-158)..NOTE: For a successful hook-up with your PC, the FilterTec Plus and the PC must use thesame communications protocol. Make sure that the communication parameters in Setup: Printerare the same as those listed in for HyperTerminal below or the default values.The FilterTec Plus is also equipped with a USB port that can be connected to your PC. You willfind the driver for this connection on the CD this manual came on. You will need to look inDevice Manager on your PC to determine the Com Port number assigned to the FilterTec Plus.The FilterTec Plus is also equipped with an Ethernet Port. Settings for the Ethernet connectionare described in section 5.4. This is for communication via Modbus TCP/IP, and when theregister list is available, it will be added to the manual as an appendix.