End Job Mode5-21Additional Technical Informationcommands perform an end of document for all of the printeremulations supported on your printer (PostScript, HP-GL, HP PCL,and Lineprinter).See your system administrator or applications development depart-ment to have them identify the standard EOD command for yourorganization, or to have them select a standard EOD command.Setting the End Job Mode for the Serial andParallel ProtocolsYour printer can be connected through the serial or parallel interfaceto a stand-alone PC, to a PC print server, or to some other type ofprint queuing system. This section provides a quick guide to the stepsneeded to set the end job mode for each environment. The followingsections provide more detailed information for each step.Stand-Alone PC1 Set the end job mode from the printer's control panel.2 Add the EOD command to your file.» Note: If using steps 1 and 2 is not feasible in your stand-alone PCenvironment, you can alternatively use a program that either causes anemulation timeout or that inserts an EOD command between each printjob. See your QMS vendor for more information on this type of program.PC Print Server1 Set the end job mode from the printer’s control panel.2 Create a job separator to append an EOD command andsend it between each print job.Other Print Queuing SystemsIf you use a print queuing system other than a PC print server andyou experience what appears to be an EOD command problem, youmay need to use another procedure, such as a print utility, an initial-ization sequence, or a header page to add an EOD command. See
