Emulations on theHard DiskQMS 1725E Print System Reference6-54will describe the procedure for copying and removing emulationson the hard disk.Installing an Optional EmulationO Caution: You must have a minimum of 12 MB of RAM to run an emulationthat has been copied to a hard disk.Use the Install Option selection from the Disk Operations menu.Refer to the instructions in chapter 4, Printer Configuration, for usingthe printer control panel. To install an optional emulation, use this pro-cedure:1 Make sure the printer is on and idle. From the Administrationmenu, select the Disk Operations submenu.2 Press the Next key until INSTALL OPTION displays.3 Press the Select key.Then press the Next key until the destination of the optional emu-lation displays in the message window.4 Press the Select key.Then press the Next key until the source of the optional emulationdisplays in the message window.5 Press the Select key.You are prompted to insert the emulation card into the card slot.6 The hard disk then copies the contents of the card. When allof the contents are copied, press the Menu key to exit themenu. Press the Online/Offline key to allow the printer toreceive data from the host.Removing a Printer EmulationUse the Remove Option menu selection if you need to remove aninstalled option from the hard drive. To remove an emulation, youneed the original emulation card containing the emulation files. The
