RCA HD56W41 User Manual

Also see for HD56W41: Technical specifications

Contents

Using the TV’s FeaturesChapter 3 43Ch 88 -888 WWWW Antenna A (Air)4:3 Normal 480i SDListening to: English in SRS FOCUSMPAA - Not Rated6060 - 2Digital or Analog TV ChannelsA single off-air antenna can pick up both analog and digital channels. Digital channels can bemade up of primary channels and subchannels.Note: Subchannels (sometimes called minor channels) are channels associated with thePrimary channel (sometimes called the major channel). A primary channel may have just onesubchannel or multiple subchannels.1. Make sure the TV is in TV mode by pressing TV on the remotecontrol.2. Enter the primary channel number (up to three digits). This numberappears in the primary channel entry box. Press OK or wait a fewseconds. If you don’t enter a subchannel, the TV tunes to the lowestsubchannel.3. If the primary channel number has fewer than three digits and youwant to enter subchannel numbers, press the right arrow button toadvance to the subchannel entry box.4. Enter the number of the subchannel. This number appears in thesubchannel entry box.5. Press OK to tune to the channel or wait a few seconds.Notes: You can always use the channel up and down buttons onthe remote control to change channels within the TV mode.You may notice the size of the channel banner changes when youchange channels. This is perfectly normal and occurs because analog(NTSC) broadcasts and digital (ATSC) broadcasts use differentformats. Your HDTV can display both types and adjusts the pictureaccordingly.If you wait too long before entering the subchannel, the TV tunesto the lowest subchannel.TipIf a digital and analog channel have the same primarychannel number, tune to the analog channel byentering the analog channel number or entering theanalog channel number and then a subchannel of “0.”PrimaryChannelSubchannel(if necessary)VOL CHCH. CTRLPIP SWAP SKIPLIGHTVCR PLUS+FREEZESOUNDTVON-OFFDVD VCRAUXSATCAB AUDIOCLEAR MENUFORMAT INFOOKGUIDETV ButtonRight ArrowTip:Use the channel banner to determinewhether a channel is digital or analog.A digital (ATSC) channel has a dash andsecond number after it (e.g., 21-1); ananalog channel doesn’t (e.g., Ch 21).