Rangemaster CLASSIC 110 GAS FSD User Manual

Also see for CLASSIC 110 GAS FSD: Installation and user guide User's guide & installation instructions User's guide & installation instructions

16Moving your cookerSwitch off the electricity supply.The cooker is heavy, two people may berequired to move it. The cooker is fitted with oneroller at the front and two at the back. There arealso two screw down levelling feet at the front.The front roller, designed for moving the cooker canbe wound down. The levelling tool that controls thisroller is in the storage drawer compartment.Remove the storage drawer (by pulling it rightout and lifting it up slightly) and you should seethe levelling tool.Your installer may not have left the levelling tool inplace. If not, locate it as shown. If you cannot findthe levelling tool, contact your installer. See theInstallation section of these instructions where yourinstaller should have written their contact details.Turn the levelling tool clockwise, two full (180°)turns. It will be stiff. The front of the oven willrise slightly as the roller drops down.Open the grill door and right hand oven door so thatyou can get a good grip on the bottom of the fasciapanel as you move the oven.Do not move the oven by pulling the hand rail,door handles or knobs.Move the oven a bit at a time, checking behind it tomake sure the gas hose is not caught. Make sureboth electricity and gas cables have sufficient slackto move the cooker forward as you go along.If a stability chain is fitted, release it as youease the cooker out.When you replace the cooker, wind it down off therollers by turning the levelling tool anti-clockwise.This is important. It will stop the cooker movingaccidentally, while in use.When you replace the cooker, wind it down off therollers by turning the levelling tool anti-clockwise.This is important. It will stop the cooker movingaccidentally, while in use.