Rangemaster CLASSIC 110 GAS FSD User Manual

Also see for CLASSIC 110 GAS FSD: Installation and user guide User's guide & installation instructions User's guide & installation instructions

21Make sure you lower BOTH REAR ROLLERS. Thereare two adjusting nuts, one for each roller, at both thefront bottom corners of the cooker.Unfold the rear edge of pack base tray. Carefully pushthe cooker backwards off the pack base and intoposition. Take care not to damage the power cable.Push the cooker close to its final position, leaving justenough space to get behind it.LevellingYou are recommended to use a spirit level on a shelfin one of the ovens to check for level.Place the cooker in its intended position taking carenot to twist it within the gap between the kitchen unitsas damage may occur to the cooker or the units.The rollers can be adjusted to level the cooker. Toadjust the height of the rear of the cooker use thelevelling tool supplied to turn the adjusting nuts at thefront bottom corners of the cooker.Adjust the height of the front roller to level the cooker.Turn clockwise to raise the cooker and anticlockwiseto lower.When you are satisfied with the height and levelraise the front of the cooker by one turn of the frontroller adjuster. Screw down the front feet to meet thefloor. Screw the front roller adjuster anticlockwise toraise the front roller so that the front of the cooker issupported on the feet, not the front roller, to preventaccidental movement of the cooker.Leave the levelling tool on the adjuster with thehandle of the tool facing the rear of the cooker, sothat the customer can use it if they wish to movethe cooker.Replace the drawer by locating on side runners andpush in.Moving the CookerThe cooker is very heavy. Take great care.We recommend two people manoeuvre the cooker.Ensure that the floor covering is firmly fixed, orremoved to prevent it being disturbed when movingthe cooker around. You will need the levelling tool.From the back tilt the cooker forward and remove therear half of the polystyrene base pack.Repeat from the front and remove the front half of thepoly base. Pull the drawer out to its furthest point. Liftit up and out.Fit the levelling tool on the rectangular adjuster asshown below.LOWER THE FRONT ROLLER by doing 14 complete(360º) turns clockwise. (This means turning andremoving the levelling tool 56 times).Now LOWER THE TWO REAR ROLLERS.First fit the levelling tool on the hexagonal adjustingnut as shown below.Make 10 complete (360º) turns clockwise. (This meansturning and removing the levelling tool 20 times).