Rangemaster CLASSIC 110 GAS FSD User Manual

Also see for CLASSIC 110 GAS FSD: Installation and user guide User's guide & installation instructions User's guide & installation instructions

24Fitting the oven burner trim(supplied with some models only)The loose oven burner trim hooks onto the front of theoven burner bracket.Oven checkThe clock must be set to the time of day before theovens will work.Press and hold as above.At the same time, press - or + until the correct timeshows.Don’t forget it’s a 24 hour clock.If you make a mistake or press the wrong button, turnoff the power supply for a minute or two and startagain.CONTROL KNOB (THERMOSTAT) CHECKIf (AUTO) is flashing, press and release the manual( ) button. Check each oven in turn. Push in and turnthe control knob to maximum. A series of sparks willoccur at the oven electrode and when the oven burnerlights the sparking will stop. A small flame will appearon the oven burner, but as this flame is ‘sensed’ by theflame supervision device, the gas flow will come onfull after a short delay. Heat each oven for 10 minutesat maximum then turn to ‘S’ and check that the flamesize has reduced. Turn off each oven and check thatthe oven burner goes out.TIMER AND SOLENOID CHECKAutomatic Operation of Timer: The gas supply toeach oven can be controlled by the timer. Set a‘cooking period’ time by pressing and releasing the () button and using the + button to give a time of2 minutes. By pressing and releasing the ‘stop time’button ( ) the stop time is displayed. Add 3 minutesto this time by using the + button. The display willautomatically change to show the time of day, thecooking symbol ( ) will go out and (AUTO) will show.Push in and turn one of the oven knobs to maximum,the timer will run until the ‘cook period’ starts, whenthe oven solenoid will open and the burner will lightautomatically. The cooking symbol ( ) will show. Atthe end of the ‘cooking period’ the solenoid will close,the oven burner will go out and the beeper will sound(the beeper may be stopped by pressing the timer () button). The flashing (AUTO) symbol is a reminderto reset to manual operation. Pressing the reset’button ( ) once to stop the beep and a second time toreturn to manual, turn off the oven knob.CONTROL KNOB (THERMOSTAT) CHECKSet timer to manual. Check each oven in turn. Pushin and turn the control knob to maximum. A series ofsparks will occur at the oven electrode and when theoven burner lights the sparking will stop. A small flamewill appear on the oven burner, but as this flame is‘sensed’ by the flame supervision device, the gas flowwill come on full after a short delay. Heat each ovenfor 10 minutes at maximum then turn to ‘S’ and checkthat the flame size has reduced. Turn off each ovenand check that the oven burner goes out.Fitting the plinthLoosen the 3 screws along the front bottom edge ofthe cooker. Hook the central keyhole over the centralscrew. Twist and fit each end keyhole over theirrespective screws. Tighten the fixing screws.Customer carePlease complete your details in this Guide, inform theuser how to operate the cooker and hand over theInstructions.Thank you.