Ransomes HR3300T Safety, Operation & Maintenance Manual

Contents

Ransomes HR3300T Safety, Operation & Maintenance Manual Manual pdf 12 page image

SAFETY, OPERATORS & MAINTENANCE MANUALen-124 SPECIFICATION4.4 HYDRAULIC SPECIFICATIONDescription Litres / Min Relief Valve Pressure Test Port LocationTransmissionForward 95 250bar see section 8.6Reverse 19 250bar see section 8.6Charge - 18barCuttingForward 68 250bar see section 8.6Reverse 45 250bar see section 8.6Steering & LiftSteering 10 125bar see section 8.6Lift 10 125bar see section 8.6Weight Transfer - 0 - 25bar4.5 VIBRATION LEVELWhen the machine was tested for hand/armvibration levels, the operator was seated in thenormal operating position with both hands on thesteering mechanism. The engine was running andthe cutting device was rotating with the machinestationary.The Machinery Safety Directive 98/37/ECBy compliance to:The Lawnmower Standard EN836:1997Referenced to Hand/Arm: EN1033:1996Information Supplied for Physical Agents Directive2002/44/ECBy reference to:Hand/Arm Standards: BS EN ISO 5349-1 (2001)BS EN ISO 5349-2 (2001)When the machine was tested for Whole Bodyvibration levels, the operator was seated in theRansomes HR3300TSeries FRJacobsen HR3300TSeries FYHand / Arm AccelerationLevelMax. LH or RHAccelerations m/s²Mean Value of X, Y, Z Aeq0.94 ± 0.56normal operating position with both hands on thesteering mechanism. The cutting device was rotatingwith the machine driven in a straight line at 6 Km/hr ona level freshly cut lawn.The Machinery Safety Directive 98/37/ECBy compliance to:Whole Body EN1032:2003Information Supplied for Physical Agents Directive2002/44/ECBy reference to:Whole Body Standards BS EN ISO 2631-1 (1997)Ransomes HR3300TSeries FRJacobsen HR3300TSeries FYWhole Body AccelerationLevelMax. SeatAccelerations m/s²Mean Value of X, Y, Z Aeq1.20Ransomes HR3300TSeries FRJacobsen HR3300TSeries FYWhole Body AccelerationLevelMax. LH or RH FootAccelerations m/s²Mean Value of X, Y, Z Aeq1.774.6 SLOPESDO NOT USE ON SLOPES GREATER THAN 14°The slope 14° was calculated using static stability measurements according to the requirements of EN 836:1997and is correct for machines without ROPS frame or ROPS cab and fitted with a rotary cutting deck.