Chapter 3: Installation and Configuration15Step 1: Configure Target ServersTarget servers are the computers that will be accessed and controlled viathe Dominion KX II. Before installing Dominion KX II, configure alltarget servers to ensure optimum performance. This configurationapplies only to target servers, not to the client workstations (remote PCs)used to access Dominion KX II remotely. Refer to Chapter 1:Introduction, Terminology (see "Terminology" on page 6) for additionalinformation.¾To configure the target servers:• Check the video resolution.• Check the desktop background.• Adjust the mouse settings.• Perform OS-specific mouse and video configuration.Supported Video ResolutionsEnsure that each target server's video resolution and refresh rate aresupported by Dominion KX II and that the signal is non-interlaced.Video resolution and cable length are important factors in the ability toobtain mouse synchronization. Refer to Target Server ConnectionDistance and Video Resolution (on page 195) for more information.Dominion KX II supports these resolutions:640x350 @70 Hz 720x400 @85 Hz 1024x768 @90 Hz640x350 @85 Hz 800x600 @56 Hz 1024x768 @100 Hz640x400 @56 Hz 800x600 @60 Hz 1152x864 @60 Hz640x400 @84 Hz 800x600 @70 Hz 1152x864 @70 Hz640x400 @85 Hz 800x600 @72 Hz 1152x864 @75 Hz640x480 @60 Hz 800x600 @75 Hz 1152x864 @85 Hz640x480 @66.6 Hz 800x600 @85 Hz 1152x870 @75.1 Hz640x480 @72 Hz 800x600 @90 Hz 1152x900 @66 Hz640x480 @75 Hz 800x600 @100 Hz 1152x900 @76 Hz640x480 @85 Hz 832x624 @75.1 Hz 1280x960 @60 Hz640x480 @90 Hz 1024x768 @60 Hz 1280x960 @85 Hz640x480 @100 Hz 1024x768 @70 Hz 1280x1024 @60 Hz
