Chapter 13: KX II Local Console281Modifying ScriptsTo modify existing scripts:1. Click Device Settings > Connection Scripts. The Connection Scriptspage opens.2. In the Available Connection Scripts section, select the script youwant to modify and click Modify. The page is then in Edit mode.3. Make changes as needed. Click OK when finished.Resetting the KX II Using the Reset ButtonOn the back panel of the device, there is a Reset button. It is recessed toprevent accidental resets (you need a pointed object to press thisbutton). The actions that are performed when the Reset button ispressed are defined on the Encryption & Share page. See Encryption &Share (on page 219).Note: It is recommended that you save the audit log prior to performing afactory reset. The audit log is deleted when a factory reset is performedand the reset event is not logged on the audit log. For more informationabout saving the audit log, see Audit Log (on page 230).To reset the device:1. Power off the KX II.2. Use a pointed object to press and hold the Reset button.3. While continuing to hold the Reset button, power the KX II deviceback on.4. Continue holding the Reset button for 10 seconds. Once the devicehas been reset, two short beeps signal its completion.
