Chapter 11: KX III Local Console349 Display Interval - changes the scan display interval. Interval Between Ports - change interval between switchingdifferent port during scan.Scan for Targets - Local ConsoleTo scan for targets:1. Click the Set Scan tab on the Port Access page.2. Select the targets you want to include in the scan by selecting thecheckbox to the left of each target, or select the checkbox at the topof the target column to select all targets.3. Leave the Up Only checkbox selected if you only want targets thatare up to be included in the scan. Deselect this checkbox if you wantto include all targets, whether up or down.4. Click Scan to begin the scan.As each target is scanned, it is displayed in slide show view on thepage.Local Console Smart Card AccessTo use a smart card to access a server at the Local Console, plug a USBsmart card reader into the KX III using one of the USB ports located onthe KX III.Once a smart card reader is plugged in or unplugged from the KX III, theKX III autodetects it.For a list of supported smart cards and additional system requirements,see Supported Smart Card Readers (on page 387), UnsupportedSmart Card Readers (on page 388) and Smart Card Minimum SystemRequirements (on page 385).When mounted onto the target server, the card reader and smart cardwill cause the server to behave as if they had been directly attached.Removal of the smart card or smart card reader will cause the usersession to be locked or you will be logged out depending on how thecard removal policy has been setup on the target server OS.When the KVM session is terminated, either because it has been closedor because you switch to a new target, the smart card reader will beautomatically unmounted from the target server.To mount a smart card reader onto a target via the KX III Localconsole:1. Plug a USB smart card reader into the KX III using one of the USBports located on the device. Once attached, the smart card readerwill be detected by the KX III.
