Regency City Series Owners & Installation Manual

Contents

16 | City Series CC40EPVowner's informationInner Glass Panel (Firebox Glass) Installation / Removal1. Remove outer safety glass panels if previously installed–see instructionsin this manual.2. CC40LE/CC40RE Single sided & CC40LE/CC40RE 3 Sided Units—Re-move outer panels installed in units - see panel removal section in this manual.Single sided units–proceed to Step 5.3. Ensure all 4 clamps on each side are open to allow clearance for the glass.Lift up side panel using supplied vacuum clamp and tilt inward and upwardpositioning into a top channel and lowering gently into the lower glass chan-nel–slide the side glass panel firmly towards the back wall until the springsat the back wall are compressed.4. With the springs compressed, close the 2 clamps at the bottom and 2 clampsat the top, by turning inward, to secure the glass in position. For the 3 sidedunit, repeat on the opposite side.Top clamps inopen positionBottom side clamps inopen positionCC40LE/CC40RE shownCC40LE/CC40RE shownBottomchannelTop clamps inclosed positionBottom clamps inclosed positionPush side glasspanel firmlyto back walluntil springs arecompressed—then closeclamps.Important:Prior to installing the inner glass, ensure that there is no media present inthe bottom channel as this can cause damage to the glass. Remove anymedia from bottom channel prior to installing the glass.WARNING: GLASS HANDLINGWe recommend using the glass vacuum holders supplied by the manufac-turer. Lower the glass to rest in a safe place, this is to prevent damage to theglass edges. Extra care must be taken when removing/installing the glass.Breakage or damage to the edge of the glass which occurs as a result ofcareless handling will not be covered under warranty.• We recommend handling the glass with supplied vacuumclamps• When removing glass–prepare a soft, scratch resistantsurface to place the glass• Never clean or remove hot glassNote: The suction cups may leave a round film on the glasswhen used. Ensure that the glass is cleaned using a fireplaceglass cleaner prior to operating the appliance.Note: glass panels must be installed to operate fireplaceTo watch the firebox installation video click here http://bit.ly/2qfQwST