Regency City Series Owners & Installation Manual

Contents

City Series CC40EPV | 3MANUFACTURED MOBILE HOME REQUIREMENTSINFORMATION FOR MOBILE/MANUFACTURED HOMES AFTER FIRST SALEThis Regency® product has been tested and listed by Warnock Hersey/Intertek as a Direct Vent Wall Furnace to the following standards:VENTED GAS FIREPLACE HEATERS ANSI Z21.88-2017 / CSA 2.33-2017 and GAS-FIRED APPLIANCES FOR USE AT HIGH ALTITUDESCSA 2.17-2017.This Direct Vent System Appliance must be installed in accordance with the manufacturer's installation instructions and the ManufacturedHome Construction and Safety Standard, Title 24 CFR, Part 3280, or the current Standard of Fire Safety Criteria for Manufactured HomeInstallations, Sites, and Communities ANSI/NFPA 501A, and with CAN/CSA Z240-MH Mobile Home Standard in Canada.This appliance installation must comply with the manufacturer's installation instructions and local codes, if any. In the absence of local codesfollow the current National Fuel Gas Code, ANSI Z223.1 and the current National Electrical Code ANSI/NFPA 70 in the U.S.A., and thecurrent CAN/CGA B149 Gas Installation Code and the current Canadian Electrical Code CSA C22.1 in Canada.This Regency® mobile/manufactured home listed appliance comes factory equipped with four 1/4" diameter holes located near each cornerof the base. Fasten the fireplace in place using screw, inserted through the holes.This appliance comes equipped with a dedicated #8 Ground Lug for attachment of the ground wire to the steel chassis as applicable to localcodes. See the "Wiring Diagram" section.The appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, with theNational Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, CSA C22.1.This appliance may only be installed in an aftermarket permanently located, manufactured home (U.S.A only) or mobile home, where notprohibited by local codes.This appliance can only be used with the type of gas indicated on the rating plate. This appliance is not convertible for use with other gases,unless a certified kit is used.Ensure that structural members are not cut or weakened during installation.