Regency City Series Owners & Installation Manual

Contents

City Series CC40EPV | 67installation919-651b 10.03.18Read the instructions below carefully and refer to the images. If the logs are broken do not use the unit until they are replaced. Brokenlogs can interfere with pilot operation.Improper positioning of the logs may create carbon build-up and can alter the unit's performance which is not covered under warranty.*Dark brown paint is included if touch ups are required.1 Rear Log2 Left Log3 Right Log4 Left Cross Log5 Right Cross Log6 Front Left Log Piece7 Front Right Log PieceLog Brackets (3)Lava rock (purchased separately from log set)1 lb Black Fireglass (purchased separately from log set)Glowing wool (supplied with unit)3/4" Crushed black glass or iceburg chips(purchased separately from log set)135246 71. S hut off gas and electrical supply, allow unit to cool to room temperature.2. Remove safety glass and firebox glass (see manual).3. Carefully remove the logs from the packaging and unwrap them.The logs are fragile, handle with care—never force into position.4. Install Black Fireglass (1.5lb) and glowing wool on the burner asshown below.Log Guides - location of log guides,2 rear - 1 front5. Clip on the log guides - position the rear guides by centering over thesecond and fourth vertical lines at the back of the burner. The frontlog guide clips on to the front edge of the burner on the right side asshown below.Log 1 in positionLog 2 in positionBurner covered with Fireglass and glowing wool1Log guides26. Centre Log 1 and rest on installed rear log guides—with pins facing up.7. Position Log 2 on the burner— the leftmost edge should be 3/4 inchesaway from the edge of the burner. The other end of the log on a slightdiagonal to the front of the firebox as shown.23/4" away from theedge of the burner1CITY LINECITY LINE - LOG INSTALLATIONOptional Driftwood Log Set Installation