Regency P33E-NG4 Owners & Installation Manual

Contents

Regency P33E-NG4 Owners & Installation Manual Manual pdf 33 page image

Regency® P33E-4 Zero Clearance Direct Vent Gas Fireplace 33INSTALLATIONGAS PIPE PRESSURETESTINGThe appliance must be isolated from the gas supplypiping system by closing its individual manual shut-off valve during any pressure testing of the gassupply piping system at test pressures equal to orless than 1/2 psig. (3.45 kPa). Disconnect pipingfrom valve at pressures over 1/2 psig.The manifold pressure is controlled by a regulatorbuilt into the gas control, and should be checkedat the pressure test point.Note: To properly check gas pressure, bothinlet and manifold pressures shouldbe checked using the valve pressureports on the valve.1) Make sure the switch is in the "OFF" position.2) Loosen the "IN" and/or "OUT" pressure tap(s),turning counterclockwise with a 1/8" wide flatscrewdriver.3) Attach manometer to "IN" and/or "OUT"pressure tap(s) using a 5/16" ID hose.4) Light the pilot by turning the switch to "ON"position.5) The pressure check should be carried out withthe unit burning and the setting should be withinthe limits specified on the safety label.6) When finished reading manometer, turn off thegas valve, disconnect the hose and tighten thescrew (clockwise) with a 1/8" flat screwdriver.Note: Screw should be snug, but do notover tighten.HIGH ELEVATIONThis unit is approved in Canada for altitudeto 4500 ft. (CAN/CGA-2.17-M91). For NaturalGas installations above 4500 ft. follow currentCAN/CGA-B149.1.886 S.I.T. VALVE DESCRIPTION1) Manual high/low adjustment2) Pilot adjustment3) Outlet Pressure Tap4) Inlet Pressure Tap5) Pilot Outlet6) Main Gas Outlet7) Main Gas InletP33E-NG4 System DataWith Flush or Bay Glass:For 0 to 4500 feet altitudeBurner Inlet Orifi ce Sizes: #44Max. Input Rating 20,000 Btu/hMin. Input Rating 14,000 Btu/hWith Contemporary Faceplate:For 0 to 4500 feet altitudeBurner Inlet Orifi ce Sizes #47Max. Input Rating 17,500 Btu/hMin. Input Rating 9,800 Btu/hSupply Pressure min.5.0" w.c.Manifold Pressure(High) 3.5"+/- 0.2" w.c.P33E-LP4 System DataWith Flush or Bay Glass:For 0 to 4500 feet altitudeBurner Inlet Orifice Sizes: #54Max. Input Rating 20,000 Btu/hMin. Input Rating 16,500 Btu/hWith Contemporary Faceplate:For 0 to 4500 feet altitudeBurner Inlet Orifice Size #56Max. Input Rating 15,500 Btu/hMin. Input Rating 9,000 Btu/hSupply Pressure min.11.0" w.c.Manifold Pressure(High) 10"+/- 0.2"w.c.PILOT ADJUSTMENTNote: If you have an incorrect flame pattern,contact your Regency ® dealer forfurther instructions.Incorrect flame pattern will have small,probably yellow fl ames, not coming intoproper contact with the rear burner or flamesensor.BurnerFlame SensorPilot IgnitorPeriodically check the pilot flames. Correctfl ame pattern has two strong blue flames:1 fl owing around the fl ame sensor and 1fl owing across the burner (it does not haveto be touching the burner).1324567