Regency P33E-NG4 Owners & Installation Manual

Contents

Regency P33E-NG4 Owners & Installation Manual Manual pdf 58 page image

58 Regency® P33E-4 Zero Clearance Direct Vent Gas FireplaceMAINTENANCEREMOVING VALVE1) Shut off the gas supply.2) Remove the louvers (and bay door if installed.)3) Open the flush door and remove the door.4) Remove the logs.5) Remove the burner/grate assembly by removing the two screwsand then lift the burner assembly out.Diagram 1: Remove the left and right screws and then lift out theburner/grate assembly.6) Remove the rear log stand by removing the 2 screws.7) Disconnect the inlet gas line.8) Disconnect the EV1, EV2, and ground wires from the valve - asshown below.Diagram 2: Rear Log Stand & Valve Tray AssemblyRear Log StandscrewsINSTALLING VALVE1) Install new valve assembly.2) Reverse steps 9-1.Diagram 3: Lift out Valve Tray Assembly9) Remove the 10 screws securing the valve tray assembly in place(diagram 2) and then lift the entire assembly out (diagram 3).EV1 EV2Ground10) Remove valve tray assembly.