Regency P33E-NG4 Owners & Installation Manual

Contents

Regency P33E-NG4 Owners & Installation Manual Manual pdf 57 page image

Regency® P33E-4 Zero Clearance Direct Vent Gas Fireplace 57MAINTENANCEGLASS GASKETIf the glass gasket requires replacement use5/8" flat glass gasket for the Bay Front (Part# 936-243) and a tadpole glass gasket for theFlush Front (Part # 936-155).DOOR GLASSYour Regency ® fireplace is supplied with hightemperature, 5 mm Neoceram ceramic glass thatwill withstand the highest heat that your unit willproduce. If your glass requires cleaning, werecommend using an approved glass cleaneravailable at all authorized dealers. Do not useabrasive materials. Do not clean the glasswhen hot.In the event that you break your glass by impact,purchase your replacement from an authorizedRegency ® dealer only, and follow our step-by-step instructions for replacement.Flush Glass ReplacementRemove the flush door front. Remove the 4glass clips from each corner. Slide in the newreplacement glass. Push the 4 glass clipsback onto the frame. The glass must havegasketing around it.Bay Glass Replacement1) Remove the door from the unit and placeon a soft surface to prevent scratching.2) Remove the nuts holding the glass clipsin place and remove.3) Replace the glass. The glass must havegasketing around it.5) Reverse the previous steps, replace theglass clips and fasten with the nuts butdo not over tighten, as this can break theglass.6) Replace door on the Fireplace and checkthe seal.Caution: Wear gloves when removingdamaged or broken glass.WARNING: Do not operate theappliance with the glass panelsremoved, cracked or broken.Replacement of the glass panelsshould be done by a licensed orqualifi ed service person.