Regency P33E-NG4 Owners & Installation Manual

Contents

Regency P33E-NG4 Owners & Installation Manual Manual pdf 48 page image

48 Regency® P33E-4 Zero Clearance Direct Vent Gas FireplaceINSTALLATIONCONTROL MOUNTING PLATEINSTALLATION(FOR P33-4 UNIT WITH FACEPLATE ONLY)1) Remove top and bottom louvers.2) Remove ON/OFF switch (for P33-4) from the bottom louver.3) Attach ON/OFF switch to control mounting plate with one screw asshown below.4) If installing the optional fan, see instructions below - otherwiseproceed with the installation of the control mounting plate.5) Install the control mounting plate over the pin, located at the left baseof the unit. Secure with 1 screw as shown.PinINSTALLING THE OPTIONAL FAN(FOR P33-4 UNIT WITH FACEPLATE ONLY)120 Volt AC power is needed for the fan switch and blower. The fan canbe hard wired if desired. The receptacle box should be installed on theleft hand side of the unit by a qualifi ed electrician. The neutral (wider) slotof the polarized receptacle should be at the top.Unit must be grounded at all times. Do not cut the ground terminaloff under any circumstances.1) Shut the power off.2) Turn the fan base on its side (with the base facing towards you) andthen slide the fan in towards the rear of the unit. Turn the fan uprightand slip it over the two mounting studs. Take care not to damage theinsulation on the fan base. Ensure that the fan blades do not rubagainst the valve tubing. Diagram 1.3) Connect fan ground cable to ground lug. Refer to wiring diagram.5) Slide the thermodisc/cover assembly into the bracket clip on the un-derside of the fi rebox. Check that no wire will touch the hot surfaces.Diagram 2.Diagram 1Diagram 2TO REMOVE THE FAN1) Shut the power off.2) Reverse the above instructions.Note: The bearings are lubricated for life. Do not lubricate them.Make sure you vacuum the fan area on a regular basis.IMPORTANT:These fans collect a lot of dust from within your home. Ensure youmaintain these fan motors on a regular basis by vacuuming out thefan blades and housing using a soft brush nozzle.9) Secure the fan wires and power cord by attaching one of the adhesivebacked wire holder clips (Part #910-199) onto the Fireplace base.Use the second clip to bundle up the wires approximately 4" fromthe control box. Ensure that there is no interference with the wireswhen the faceplate and trim are installed and that no wire will touchthe hot metal surfaces or sharp edges.10) Plug the fan power cord into the rear end of the receptacle box toprovide the maximum clearance.11) Clip the fan control box to the ON/OFF switch (already installedon the control mounting plate. Secure the fan control box withone screw as shown below.12) Install control mounting plate to unit (see step 5 this page).CONTEMPORARY FACEPLATE INSTALLATION PART 2