Regency® P33E-4 Zero Clearance Direct Vent Gas Fireplace 49INSTALLATION1) Install the control shield with 2 #8 - 1/2" Phillips screws to the bottomof the flush door as shown in Diagram 1.3) Loosen 4 phillips head screws located inside firebox, for screw locationssee Diagram 4. Install mounting frame and retighten screws.4) After the frame has been installed, locate the 2 phillips head screwson lower part of the mounting frame- see Diagram 3 for location.Slide on the 2 faceplate supports and retighten the screws.5) The top of the faceplate has a fl ange that hooks over the top of thefl ush door.2) Install the heat deflector on the fi re box as shown in Diagrams 2 &3.Loosen 3 Phillips head screws already in fi rebox, slide heat defl ectoron to screws and retighten.Diagram 1Diagram 2Top of Unit Heat DeflectorDiagram 3Diagram 4Diagram 5BendDiagram 6FlangeMounting FrameHeat DeflectorControl ShieldFaceplate SupportFaceplate434-033 Mounting Plate434-514 Faceplate Support434-032 Control Shield434-018F Heat Deflector434-516 Faceplate - Black434-516BL Faceplate - Blue434-516R Faceplate - Red434-517 Faceplate - Stainless SteelImportant: Positon of bracket must be as shown in Diagram 5, withbend away from fireplace.CONTEMPORARY FACEPLATE INSTALLATION PART 3
