Regency® P33E-4 Zero Clearance Direct Vent Gas Fireplace 51INSTALLATIONOptionalWALL SWITCH1) Run the supplied 10' of wire through the rightor left side gas inlet opening. Be careful not todamage wire.Note: We recommend a maximum of 10' ofwire but if you wish to go with a longerrun, use the Thermostat Wire Table.2) Connect the wire to a wall switch and installinto the receptacle box. Also attach wires tothe valve as shown below.OptionalWALL THERMOSTATA wall thermostat may be installed if desired,connect the wires as per the wiring diagram. Usetable below to determine the maximum wire length.Note: Preferable if the thermostat is installedon an interior wall.Regency ® offers an optional programmablethermostat but any 250-750 millivolt rated non-anticipator type thermostat that is CSA, ULC orUL approved may be used.Thermostat Wire TableOptionalREMOTE CONTROLUse the Regency ® Remote Control Kit approvedfor this unit. Use of other systems may void yourwarranty.The remote control kit comes with a hand heldtransmitter, a receiver and a wall mounting plate.1) Choose a convenient location on the wall toinstall the receiver and the receptacle box(protection from extreme heat is very important).Run wires from the fireplace to that location.2) Connect the two wires to the gas valve. Seewiring diagram. Optional wall switch GT/GTM/GTMF using wire 0.584.9073) Install 3 AAA alkaline batteries in transmitter and4 AA alkaline batteries in the receiver. Installthe receiver and its cover in the wall. Switchthe remote receiver to "remote" mode. Theremote control is now ready for operation.Recommended Maximum Lead Length(Two-Wire) When Using WallThermostat (CP-2 System)Wire Size Max. Length14 GA. 50 Ft.16 GA. 32 Ft.18 GA. 20 Ft.20 GA. 12 Ft.22 GA. 9 Ft.BATTERY INSTALLATION1) 4 AA batteries must be installed in the battery pack to operate the burner switch.2) Install 2 AA batteries per side and connect as shown below.CAUTIONDo not wire millivoltwall thermostat wiresto 120V wire.CAUTIONDo not wire millivoltremote control wiresto 120V wire.CAUTIONDo not wire millivoltwall switch wiresto 120V wire.