CHAPTER 4. AP Connection Management© SAMSUNG Electronics Co., Ltd. page 167 of 6894) To check the configured apc list, execute the ‘show apc summary’ command.5) To check the redundancy information, execute the ‘show redundancy summary’command.6) To check the configured AP profile, execute the ‘show ap detail [AP_PROFILE_NAME]’ command.Configuration using Web UI1) By referring to the ‘APC List Management’, add the APC list that will be used as abackup APC.2) In the menu bar of , select and then selectthe menu in the sub-menus. Operator can add ordelete the APC list that will be used for redundancy. If necessary, operator canconfigure the fallback function.Figure 85. Redundancy Configuration WindowParameter DescriptionAPC NAME Name of an APC to be added or deleted to/from redundancyThe APC must be an APC registered in the APC list.MAC ADDRESS Because this is a MAC address configured during registration to the APC list,an operator does not have to enter this at the redundancyconfiguration stage.IP_ADDRESS IP address of an APC to addThis address is an IP required by an AP to connect to the APC.Therefore, you must enter the AP Management IP address of the APC.PORT CAPWAP PORT number of the APC to addIf no port number is entered, it is set to 5246, the default port number ofCAPWAP protocol. It is recommended not to use a different port number if it isspecially required.PUBLIC_IP_ADDRESSPUBLIC IP address of the APC to addThis address is an IP required by an AP to connect to the APC. If the APC is in
