CHAPTER 4. AP Connection Management© SAMSUNG Electronics Co., Ltd. page 201 of 6892) Configure how to transmit the time information to an AP using ‘ac-stamp’ andconfigure the interval. mode ac-stamp ac-stamp-interval [INTERVAL]3) To check the information, execute the ‘show apc ap-time-config’ command.Configuring NTP type using CLI1) Go to configure apc ap-time-config configuration mode of CLI.WEC8500# configure terminalWEC8500/configure# apcWEC8500/configure/apc# ap-time-configWEC8500/configure/apc/ap-time-config#2) Add the NTP server information to transmit to an AP. Maximum 10 NTP serverinformation can be added. To delete the configured NTP server information, enter ‘no’parameter in front of the command add-ntp [NTP_SERVER_ADDRESS] no add-ntp [NTP_SERVER_ADDRESS] ntp-interval [NUMBER]3) Configure the method of transmitting the time information to an AP as ‘ntp’. mode ntp4) Use the ‘show apc ap-time-config’ command to check the configured information.Configuration using Web UIIn the menu bar of , select , select in thesubmenu, and then select a time setting mode of the AP (TimeStamp or NTP), timestampinterval, and NTP polling interval. Also, you can add/remove NTP server from which tofetch time access information for the AP.Figure 105. AP Time Synchronization Configuration Options
