CHAPTER 8. Security© SAMSUNG Electronics Co., Ltd. page 453 of 6898.8 External BYOD ServerThe W-EP WLAN system provides a function of interoperating with the external BYODserver. To use the BYOD function, a separate BYOD server is necessary. Employees andguest users can receive a service after being connected to a specific WLAN (SSID) andgoing through authentication.(The external BYOD server now supported is only AirCuve BYOD.)8.8.1 Configuring External BYOD ServerConfiguration using CLITo configure the interoperation with external BYOD, execute the command as follows:1) Go to configure security byod of CLI.WEC8500# configure terminalWEC8500/configure# security byod2) Enter the IP address of the BYOD server.WEC8500/configure/security/byod# address1 10.10.10.20To interoperate with AirCuve BYOD Suite, enter Airfront IP in address1 and ByfrontIP in address2.3) Enable the function of interoperating with the external BYOD server.WEC8500/configure/security/byod# enable4) Configure a HTTPS request URL.Upon the interoperation with AirCuve BYOD Suite, the HTTPS request URL isnecessary to update the list of all authentications. The basically set value is used and ifchange is required in the future, change as follows:WEC8500/configure/security/byod# https-requrlregist.do?cmd=dhcpTableXMLReceiver5) To check the configured environment, use the ‘show security byod configuration’command.
