CHAPTER 1. Access Point Controller System Overview© SAMSUNG Electronics Co., Ltd. page 29 of 689When connecting a cable to the management port, make sure to check if the cable complieswith the 10 BASE-T, 100 BASE-TX, or 1000 BASE-T. Cable type: UTP or STP cable using RJ-45 connector 10 BASE-T: Category 3 or higher 100 BASE-TX: Category 5 or higher 1000 BASE-T: Category 5 or higher (Category 5e or higher is recommended) Isolate from wireless frequency disturbing waves Shut down electrical surge Separate the electrical wiring of a switch or related devices and the electromagneticarea of network data line Cable or connector and safe connection without damaged cable sheathThe 1000 BASE-T standard does not support the forced mode.The auto-negotiation function must be always used for 1000 BASE-T port or trunkconnection.Optic portIt provides two 10 GbE Optic ports and eight 1 GbE Optic ports and the operational statusof each port is displayed in LED.Figure 6. Optic port configurationConfiguration item Port/LED Description10 GE ports LINK/ACT 1, LINK/ACT 2 LINK/ACT status of each port- Turned on for link connection- Blinking for data exchange10G 1, 10G 2 10 GbE Optic module connector1 GE port LINK/ACT 1~LINK/ACT 8 LINK/ACT status of each port- Turned on for link connection- Blinking for data exchange1G 1~1G 8 1 GbE Optic module connector1G portLINK/ACT LED1G portConnector10G portConnector10G portLINK/ACT LED
