CHAPTER 7. WLAN Additional Services© SAMSUNG Electronics Co., Ltd. page 374 of 6897.15.3 Setting AP ParametersStation-based Adaptive Load Balancing operates as the default value of the setting of theAP group but it is possible to set other parameter value to an individual AP. Because itoperates in a radio unit, the parameters to change must be set to the individual radio of thecorresponding AP must be set.Configuration using CLITo set AP parameters, execute the command as follows:1) Go to the load-balancing configuration mode in configure AP of CLI.APC# configure terminalAPC/configure# ap ap_1APC/configure/ap ap_1# load-balancingAPC/configure/ap ap_1/load-balancing#2) Go to the radio to perform the Station-based Adaptive Load Balancing function.APC/configure/ap ap_1/load-balancing# radio 1APC/configure/ap ap_1/load-balancing/radio 1#3) Activate load balancing in the corresponding radio. enable4) Set the station threshold to perform the Load Balancing function. interval [NUMBER]Parameter DescriptionNUMBER Interval for performing load balancing (sec)5) Set the station threshold to perform the Load Balancing function. threshold [NUMBER]Parameter DescriptionNUMBER Station threshold as the standard for the performance of loadbalancing6) Set the time of blocking the reconnection after the load of the station is now balanced. kickout-timeout [NUMBER]
