RECORDING320 EnglishOPERATIONUse the following procedure to automatically record alarmvideo to the alarm recording area when an alarm signal isdetected.Recording will not be possible until a time has been set forthe digital video recorder. Make sure to set the time. (JP.43)1 Set alarm recording.Follow the instructions on P.68 set “7. ALARM REC MODESET” from .2 Press the [EXIT] button.The setting procedure is ended and the normal screen isdisplayed.z When an alarm signal is detected, “ALARM” flashes inthe operation display and the alarm recording starts(indicated by “REC”).z Alarm video is recorded to the alarm recording area.z Whenever an alarm occurs, the number of alarms asindicated in the operation display is incremented.z If an alarm occurs during normal recording or timerrecording, the recording operation will be ended.z A maximum of 16,000 alarm recordings can be madeon one hard disk. If hard disk expansion is carried out,this number can be increased to 32,000. Note,however, since settings for each condition will affect themaximum number of recordings that can be made, besure to check menu settings and display content.3 End alarm recording.When the alarm duration has expired (default setting: 20seconds), both “REC” and “ALARM” finish flashing fromthe operation display and recording stops.z When the space remaining in the alarm recording areadrops below a preset value, the FULL indicator on thedigital video recorder’s front panel starts to flash. Ifrecording is continued beyond this point, the alarmrecording area will become full, recording will stop, andthe FULL indicator will stop flashing and remain lit. Insuch a case, use the menuto perform “AREA FULL RESET” for the alarmrecording area, thus allowing recording to start againfrom the beginning. (JP.60)[EXIT] buttonALARM FULL indicatorPOWER indicator[REC/STOP] button [TIMER] buttonAlarm recordingEXITWhen an alarm signal is detected01-01-04 00:00:00 REC REPEAT EN A ALARM 000002Counts the numberof alarms.Values between0000 and 9999 canbe displayed.
