Sanyo DSR-3506 Instruction Manual

Also see for DSR-3506: Service manual Quick guide

Contents

Sanyo DSR-3506 Instruction Manual Manual pdf 78 page image

GENERAL SET4English 774 Turn the shuttle dial clockwise.The cursor moves to the time entry.The following settings are carried out using the shuttledial and jog dial.z Vertical cursor movement: Turn the jog dial.z Cursor movement to the right: Turn the shuttle dialclockwise.z Modification of values: Turn the shuttle dial clockwise,and then with the setting value flashing, turn the jog dial.z Confirmation of values: Turn the jog dial clockwise.5 Perform the following if so required.(2) TIME (OFF):Time is not displayed during recording or playback.(3) QUALITY (OFF):Picture quality mode is not displayed during recordingor playback.(4) AUDIO (OFF):Audio recording settings are not displayed duringrecording or playback.(5) ALARM COUNT (OFF):The current number of alarms is not displayed.(6) ALARM TYPE (OFF):The type of alarm recording is not displayed.(7) TITLE (OFF):Camera titles are not displayed. The content of the operation display areachanges when the setting for “ALARMRECORDING” from (JP.68) MODE SET> is switched.When turned “OFF”:The alarm count and type are not displayed.When turned “ACTIVE”:The operation display area changes as follows.z “ALARM” is displayed when alarm video is recorded orplayed back.z “PRE” is displayed when pre-alarm video is recorded orplayed back.z “ARCHIV” is displayed for playback from the archive area.6 Press the [EXIT] button.The setting procedure is ended and the display returns tothe normal screen.z A maximum of 9,999 alarms can be displayed in theoperation display area. When this number is exceeded,the count returns to 0000.Use the following procedure to display “VIDEO LOSS!”when the camera video is interrupted.1 Turn the jog dial to select “VIDEOLOSS”, and then turn the shuttle dialclockwise.2 Turn the jog dial to display “ON”, andthen turn the shuttle dial clockwise.3 Press the [EXIT] button.The setting procedure is ended and the display returns tothe normal screen.z After “VIDEO LOSS” is detected, it can be cancelled byperforming either of the following.(1) Input a video signal.(2) If no video input is required, use a [CAMERASELECT] button to select the camera for which videoloss was detected and then press and hold the samebutton.EXITSetting display for video lossEXIT