RECORD SET372 EnglishSETTINGSUse the following procedure to set motion sensor on videofrom each camera so that alarms can be detected.(1) Motion sensor settingDisplays changes in response to the sensor condition,and settings are made turning the jog dial.-: Sensor offA or B: Sensor on(2) Camera number displayChanges when a [CAMERA SELECT] button ispressed. Use this item to select the camera for whichmotion sensors are to be setup.(3) Time periodSelect an interval as set using “TIME PERIOD” onP.50.(4) LEVELSets the sensitivity level of the motion sensors.OFF: No motion sensor has been set.1 to 10: A motion sensor is set. Lower valuescorrespond to higher sensitivity levels and vice versa.(5) MODESets the detection method for the motion sensors.(JP.72)z Refer to “NAMES AND FUNCTIONS OF PARTS” formore details regarding operation of the jog dial andshuttle dial. (JP.8)1 Make timer settings for “TIME PERIODA” and “TIME PERIOD B” from PERIOD SET>. (JP.50)2 Turn the jog dial select “MOTIONSENSOR”, and then turn the shuttle dialclockwise.The motion sensor screen is displayed.3 Press the [CAMERA SELECT] button.Select the camera for which motion sensors are to besetup.4 Turn the jog dial clockwise or counter-clockwise to move the cursor (blue) tothe position where a sensor is to be set.5 Turn the shuttle dial clockwise, andthen turn the jog dial to select “A” or“B”.“A” or “B”: Sensor set“-” : No sensor6 Turn the shuttle dial clockwise.After confirming this setting, the cursor (blue) moves oneposition to the right.7 Use this procedure to set other sensorpositions.Setting the motion sensors(1)(2)(3) (4) (5)Motion sensorscreenThe cursor (blue) isdisplayed at the top leftposition.
