Sanyo PLC-WU3800 Owner's Manual

Also see for PLC-WU3800: Dimensional drawing Manual Manual Command list Specification sheet

Contents

10Part Names and FunctionsRear Terminalᶈ S-VIDEO INConnect the S-VIDEO output signal from videoequipment to this jack (p.16).ᶋ AUDIO INConnect the audio output signal from videoequipment connected to ᶈ or ᶌ to this jack.For a mono audio signal (a single audio jack),connect it to the L (MONO) jack (p.16).ᶊ COMPUTER 1 COMPONENT / COMPUTER AUDIO INConnect the audio output (stereo) from acomputer or video equipment connected to ᶄ,ᶅ or ᶆ to this jack. (pp.15, 17)ᶌ VIDEO INConnect the composite video output signal tothis jack (p.16).ᶄ COMPUTER IN 1 / COMPONENT INConnect output signal from a computer, RGB scart21-pin video output or component video output tothis terminal (pp.15,17).ᶉ AUDIO OUT (VARIABLE)Connect an external audio amplifier to this jack(pp.15 -17).This terminal outputs sound from AUDIO IN terminal(ᶊ or ᶋ).Never plug headphones and earphones into AUDIOOUT jack.ᶇ LAN Connection TerminalConnect the LAN cable (refer to the owner’s manualof “Network Set-up and Operation”).ᶄ ᶅᶃ ᶆᶉᶊᶋᶃ CONTROL PORTWhen controlling the projector with RS-232C,connect the control equipment to this connector withthe serial control cable.ᶌᶇᶈᶆ HDMIConnect the HDMI signal (including sound signal)from video equipment or the DVI signal fromcomputer to this terminal (pp.15, 17).ᶅ COMPUTER IN / MONITOR OUT– Connect computer output to this terminal (p.15).– This terminal can be used to output the incominganalog RGB signal and component signals fromCOMPUTER IN 1/COMPONENT IN terminal to theother monitor (p.15).* is registered trademarks of HDMILicensing, LLC.*