Sanyo PLC-XE45 Owner's Manual

Also see for Think GAIA PLC-XE45: Technical details Service manual

Contents

Connect the projector’s AC power cord into an ACoutlet. The POWER indicator turns red.Press the POWER ON-OFF button on the remotecontrol. The POWER indicator becomes green and thecooling fans start to operate. The preparation displayappears on the screen and the count down starts.231The preparation display disappears after 30 seconds.4 After the countdown, the input source that wasselected the last time and the Lamp mode status icon(see page 46) will appear on the screen.If the projector is locked with a PIN code, a PIN codeInput Dialog Box appears. Enter the PIN code asinstructed below.See page 46 for the Lamp mode.Selected Input Source and Lamp ModeComplete peripheral connections (with a computer,VCR, etc.) before turning on the projector.Lamp modeAfter the OK icondisappears, you canoperate the projector.PIN Code Input Dialog BoxTurning On the ProjectorEnter a PIN codeSelect a number by pressing the Point ed buttons, andthen press the Point 8 button to fix the number and movethe pointer. The number changes to "✳". If you fixed anincorrect number, move the pointer to the number you wantto correct by pressing the Point 7 button, and then selectthe correct number by pressing the Point ed buttons.Repeat this step to complete entering a four-digit number."1234" is set as the initial PIN code at the factory.After entering the four-digit number, move the pointer to"Set" by pressing the Point 8 button. Press the SELECTbutton so that you can start to operate the projector.If you entered an incorrect PIN code, "PIN code" and thenumber (✳✳✳✳) turns red. Enter the correct PIN code allover again.What is PIN code?PIN (Personal Identification Number) code is a securitycode that allows the person who knows it to operate theprojector. Setting the PIN code prevents unauthorized useof the projector.A PIN code consists of a four-digit number. Refer to the PINcode lock function in the Setting Menu on pages 47–48 forlocking operation of the projector with your PIN code.✔Note:• When the Input Search function is set onOn1 or On2, the input signal will be searchedautomatically (p.45).• When the Logo select function is "Off,” thelogo will not be displayed on the screen(p.42).• When the "Countdown off" or "Off" is selectedin the Display function, the countdown willnot be shown on the screen (p.41).• During the countdown period, all operationsare invalid.• If the correct PIN code number is not enteredfor 3 minutes after the PIN code dialog boxappeared, the projector will be turned offautomatically.• The “1234” is set as the initial PIN code atthe factory.CAUTION ON HANDLING THE PIN CODEIf you forget your PIN code, the projector can nolonger be started. Take a special care in setting anew PIN code; write down the number in a columnon page 68 of this manual and keep it at hand.Should the PIN code be missing or forgotten,consult your dealer or service center.1816Basic Operation