Sanyo PLC-XU75 Owner's Manual

Contents

25Computer Input5Choose either Computer 1 or Computer by pressingthe INPUT button on the top control or press theCOMPUTER button on the remote control. Beforeusing these buttons, correct input source should beselected through Menu operation as described below.Input Source SelectionDirect OperationComputer 1COMPUTER buttonINPUT button✳ See Note at the bottom of this page.✳Remote ControlTop ControlINPUT buttonCOMPUTER buttonComputer 2VideoComputer 1✳Computer 2Input MenuInput MenuMove the pointer (redarrow) to Computer 1 andpress the SELECT button.Input Menu iconMove the pointer (redarrow) to Computer andpress the SELECT button.Move the pointer to RGBand press the SELECTbutton.Source Select MenuComputer1Press the MENU button to display the On-ScreenMenu. Press the Point 7 8 buttons to move thered framed pointer to the Input Menu icon.1Press the Point ed buttons to move the redarrow pointer to either Computer 1 or Computer, and then press the SELECT button.2After the Source Select Menu appeared forComputer 1, move the pointer to RGB and thenpress the SELECT button.3Menu Operation✔ Note:• When the Input Search function is set On1or On, the input signal will be searchedautomatically (p.46)• C o m p u t e r i s n o t d i s p l a y e d w h e n t h eCOMPUTER IN /MONITOR OUT terminal is setas Monitor out. (p.47)• Computer (COMPUTER IN /MONITOR OUT)can accept only RGB signal.