Compliance7Federal Communications Commission NoticeNote: This equipment has been tested and found to comply with the limits for a Class B digital device,pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection againstharmful interference in a residential installation. This equipment generates, uses, and can radiate radiofrequency energy, and if not installed and used in accordance with the instructions, may cause harmfulinterference to radio communications. However, there is no guarantee that interference will not occur in aparticular installation. If this equipment does cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on, the user is encouraged to try to correct theinterference by one or more of the following measures:– Reorient or relocate the receiving antenna.– Increase the separation between the equipment and receiver.– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.– Consult the dealer or an experienced radio/TV technician for help.Use of shielded cable is required to comply with class B limits in Subpart B of Part 15 of FCC Rules.Do not make any changes or modifications to the equipment unless otherwise specified in the instructions. Ifsuch changes or modifications should be made, you could be required to stop operation of the equipment.Model Number : PLC-XU75/PLC-XU78Trade Name : SanyoResponsible party : SANYO FISHER COMPANYAddress : 1605 Plummer Street, Chatsworth, California 91311Telephone No. : (818)998-73The AC Power Cord supplied with this projector meets the requirement for use in the country you purchased it.AC Power Cord for the United States and Canada:AC Power Cord used in the United States and Canada is listed by the UnderwritersLaboratories (UL) and certified by the Canadian Standard Association (CSA).AC Power Cord has a grounding-type AC line plug. This is a safety feature to be surethat the plug will fit into the power outlet. Do not try to defeat this safety feature. Shouldyou be unable to insert the plug into the outlet, contact your electrician. GROUNDAC Power Cord RequirementAC Power Cord for the United Kingdom:This cord is already fitted with a moulded plug incorporating a fuse, the value of which is indicated on the pinface of the plug. Should the fuse need to be replaced, an ASTA approved BS 136 fuse must be used of thesame rating, marked thus ASA . If the fuse cover is detachable, never use the plug with the cover omitted. If areplacement fuse cover is required, ensure it is of the same colour as that visible on the pin face of the plug(i.e. red or orange). Fuse covers are available from the Parts Department indicated in your User Instructions.If the plug supplied is not suitable for your socket outlet, it should be cut off and destroyed.The end of the flexible cord should be suitably prepared and the correct plug fitted. (See Over)WARNING : A PLUG WITH BARED FLEXIBLE CORD IS HAZARDOUS IF ENGAGED IN A LIVE SOCKETOUTLETThe Wires in this mains lead are coloured in accordance with the following code:Green-and-yellow . . . . . . EarthBlue . . . . . . . . . . . . . . . . . NeutralBrown . . . . . . . . . . . . . . . LiveAs the colours of the wires in the mains lead of this apparatus may not correspond with the colouredmarkings identifying the terminals in your plug proceed as follows:The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is markedby the letter E or by the safety earth symbol or coloured green or green-and-yellow.The wire which is coloured blue must be connected to the terminal which is marked with the letter N orcoloured black.The wire which is coloured brown must be connected to the terminal which is marked with the letter L orcoloured red.WARNING: THIS APPARATUS MUST BE EARTHEDTHE SOCKET-OUTLET SHOULD BE INSTALLED NEAR THE EQUIPMENT AND EASILy ACCESSIBLE