Sanyo PLC-XW250 - 2600 Lumens Manual

Also see for PLC-XW200: Owner's manual Owner's manual Specification sheet Specification sheet Specifications

Contents

PLC-XW200/250 Expand Serial Command Functional Specifications31 / 648.10.4 CF_AUTOSETUPPCADJ CommandCommand “CF_AUTOSETUPPCADJ_%1”[CR]%1 “ON” ------------------- Set Auto PC ADJ. function to ON“OFF” ------------------ Set Auto PC ADJ. function to OFFDetailsSet/Cancel Auto PC adj. functionThis command is available in normal Power ON status.Note) It is unable to set Keystone, PC ADJ. and Input search to OFF at once.e.g. If projector receives Auto PC ADJ. OFF command while Keystone and Inputsearch are OFF, it returns error code “101”.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]8.10.5 CF_AUTOSETUPKEYSTONE CommandCommand “CF_AUTOSETUPKEYSTONE_%1”[CR]%1“AUTO” ------------------- Set Auto Keystone function to Auto“MANUAL” --------------- Set Auto Keystone function to Manual“OFF” --------------------- Set Auto Keystone function to OFFDetailsSet Keystone function of Auto setupThis command is available in normal Power ON status.Note) It is unable to set Keystone, PC ADJ. and Input search to OFF at once.e.g. If projector receives Keystone OFF command while Auto PC ADJ. and Inputsearch are OFF, it returns error code “101”..Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]8.10.6 CF_AUTOSETUP CommandCommand “CF_AUTOSETUP_%1”[CR]%1 “START” ------------------- Execute Auto SetupDetailsExcute Auto SetupNote) CF commands does not execute while Auto setup is in process. If thecommand is sent during this, projector returns error code “302”Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]8.10.7 CF_BACKGND CommandCommand “CF_BACKGND_%1” [CR]%1“BLUE” -------------------- Select Blue Back“USER” ------------------- Select User“BLACK” ------------------ Select Black Back“UP” ---------- Switch forward (Blue Back→User→Black Back→Blue Back)“DN” --------- Switch backward (Blue Back→Black Back→User→Blue Back)DetailsSet Screen status for no signal.(Available only in the normal Power ON status)The status set by this command is stored in EEPROM and the setting remainseven after the power is turned to ALL OFF status.*When 1=”USER” is received, error code “101” is returned, in the case ofCapture non-practice.Response Acceptable “000” [CR]Unacceptable “Error Code” [CR]