TB8100 Service Manual Reciter Fault Finding 75© Tait Electronics Limited September 20063.4 Board ReplacementReplacing FaultyBoards At certain stages during the fault finding procedure, you will be instructedto replace the system interface board. In these cases, go to “Reciter BoardReplacement” on page 103 and carry out the board replacement proceduresdescribed there. The full procedure will normally involve:■ removing the faulty board■ fitting a new board■ carrying out the specified reprogramming and recalibration tasksusing the Calibration Kit■ carrying out the procedures described in “Final Tasks” onpage 95.Refer to “Reciter Spare Parts” on page 109 for a full description of thespares available for the reciter.Disposing of FaultyBoards We recommend that you dispose of faulty boards according to your localenvironmental and safety regulations. Otherwise, return them to yournearest CSO for appropriate disposal.
