Jun 04 Publication No. GEG-99199TallyGenicom Intelliprint mL260 User Guide 7-17Solving 550 Sheet Feeder Problems■ If the paper feeder is inoperative after installation, refer to “Installation Problems” on page7-17 and complete the recommended procedure.■ If the printer control panel displays an error message or an error code, refer to “InterpretingPaper Feeder Error Messages” on page 7-17.■ If you have a paper feeder problem but the printer control panel does not display an errormessage or error code, refer to “Correcting Miscellaneous Paper Feeder Problems” on page7-19 and follow the directions for correcting that problem.Interpreting Paper Feeder Error MessagesThe printer control panel displays error messages when there is a problem with the printer or any ofthe optional paper-handling components. The following table lists all of the error messages associ-ated with the 550 sheet paper feeder, the possible cause of the error, and the action to take to correctthe problem. If the control panel shows an error message that concerns another part of the printer,refer to Chapter 5: Troubleshooting for a complete list of all warning and error messages.Installation ProblemsSimple oversights during installation may cause problems when you first use the paper feeder. If thepaper feeder is inoperative after you have installed it, use the following procedure to check severalpossible causes.Error or WarningMessage Line 1Error or WarningMessage Line 2Possible Cause Action(Warning message, printercontinues operating and line1 shows printer status.)Paper Out Tray 2(applies to first paperfeeder if installed)There is no paper intray 2.Add paper to the tray.Paper Out Tray 3(applies to secondpaper feeder ifinstalled)There is no paper intray 3.Add paper to the tray.TRAY 2 MISSING(applies to first paperfeeder if installed)Insert Tray Tray 2 is not installed. Install the tray.TRAY 3 MISSING(applies to second paperfeeder if installed)Insert Tray Tray 3 is not installed. Install the tray.E2-1 JAM MISFEED Remove paper There is a misfeed jamnear the source papertray.Remove the jammedpaper from the sourcetray.LOAD PAPER TRAY2(applies to first paperfeeder if installed)Paper Size/Paper TypeTray 2 is empty. Load paper into the tray.LOAD PAPER TRAY3(applies to second paperfeeder if installed)Paper Size/Paper TypeTray 3 is empty. Load paper into the tray.OPTION TRAY FAILCall ServiceTurn printer off then on. Ifproblem persists, call yourservice provider.
