Jun 04 Publication No. GEG-99199TallyGenicom Intelliprint mL260 User Guide 9-7Testing the Offset Catch Tray10. Push the tray in until it matches the size of paper that will be printed.11. Insert the plug of the power cord into the AC outlet and turn the printer on by pressing[ I ] on the power switch on the front left of the printer.12. Check the display to make sure the printer is ready for printing.NOTE: If an error message is shown when you turn the printer on, refer to Chapter 5:Troubleshooting.Testing the Offset Catch TrayAfter installing the offset catch tray, use the following test procedure to verify that it is operatingcorrectly.1. Turn the printer on by pressing the [ I ] on the power switch on the front left of the printer.2. Once the printer has warmed up and displays the “Ready” message on the control panel dis-play, use any software application to print a few sheets to the offset catch tray.3. If the feeder does not feed paper or if the control panel displays an error message, referto“Solving Offset Catch Tray Problems” on page 9-7.Solving Offset Catch Tray ProblemsWhen there is a problem with the offset catch tray, the printer control panel displays an error codeand error message. Most offset catch tray error codes indicate routine status conditions such as apaper jam. Some error codes indicate much more serious problems that may require the help of aservice technician.■ If the offset catch tray is inoperative after installation, refer to “Installation Problems” onpage 9-8 and complete the recommended procedure.■ If the printer control panel displays an error message or an error code, refer to “InterpretingOffset Catch Tray Error Messages” on page 9-8.■ If you have an offset catch tray problem but the printer control panel does not display anerror message or error code, refer to “Correcting Miscellaneous Offset Catch Tray Prob-
