Jun 04 Publication No. GEG-99199TallyGenicom Intelliprint mL260 User Guide 3-19System MenuSystem MenuThe system menu provides access to system settings. Use the following procedure to enter the sys-tem menu:1. Press the MENU button on the control panel.2. Press the NEXT button until the text “System Menu” is shown on the second line of the dis-play.3. Press the SELECT button to enter the system menu.4. Press the NEXT button to move through the submenus: Factory Defaults, Display Lan-guage, Power Saver, Wait Timeout, Job Timeout, Jam Recovery, and Hex Print.5. Press the SELECT button to enter a submenu.6. Use the procedures in the following table to access and change the system settings:Submenus Default Setting Available Settings Procedure for Changing SettingFactory DefaultsThis submenu allows you to resetthe printer to U.S. or Non-U.S.factory defaults.U.S. U.S.Non-U.S.1. Press NEXT or PREVIOUS to togglesbetween U.S. and NON-U.S.2. Press SELECT to choose and setthe factory defaults.Display LanguageThis submenu allows you to changethe language of the displaymessages.English EnglishFrenchGermanItalianSpanish1. Press NEXT or PREVIOUS to scrollthrough the available languages:English, French (Francais), German(Deutsch), Italian (Italiano), orSpanish (Espanol).2. Press SELECT to choose and setthe language.Power SaverThis submenu allows you to set thenumber of minutes the printer isidle before it reverts to PowerSaver Mode.15 0 - 999 1. Press NEXT or PREVIOUS toincrease or decrease the number ofminutes.2. Press SELECT to save this setting.Wait TimeoutThis submenu allows you toincrease or decrease the length oftime (in seconds) that the printerwill remain in the waiting state—ajob is being processed, noend-of-file has been detected, andthere is no more data to process.This setting applies to both PCLand PostScript print jobs.20 0 - 99999 1. Press NEXT or PREVIOUS toincrease or decrease each digit ofthe five-digit number.2. Press SELECT set one digit andmove to the next digit.3. Press SELECT after changing thelast digit to save this setting.Job TimeoutThis submenu allows you toincrease or decrease the time limit(in seconds) for PostScript jobs. A0 setting indicates no timeout. Thissetting applies only to PostScriptjobs.0 0 - 99999 1. Press NEXT or PREVIOUS toincrease or decrease each digit ofthe five-digit number.2. Press SELECT set one digit andmove to the next digit.3. Press SELECT after changing thelast digit to save this setting.
