TASCAM DP-006 172 – Quick Start Guides4. In order to use the built-in MIC B to record the guitar to stereo TRACK 3,use the DATA wheel to set the input source for IN B(INPUT B) to INTMIC B-Low, INT MIC B-Midor INT MIC B-High. (See “Selectingthe input source” on page 51.)5. After completing the setting, press the HOME button to return to theHome Screen.NOTE• INT.MIC X-Low, INT.MIC X-Midand INT.MIC X-High(Xis Aor B) settings change the sensitivity of the built-in mics. Set according tothe loudness of the subject being recorded.If you are not sure which setting to use, choose INT.MIC X-Low. If theinput level is still too low after adjusting it, return to INPUT SETTINGscreen and change the setting to INT.MIC X-Mid. If the input level isstill not high enough, change the setting to INT.MIC X-High.• Set the MODEitem on the INPUT SETTINGto monitor the inputsignals. (See “Setting the monitoring mode” on page 52.)Setting the internal mics as the recording sourcesfor TRACK 3When the recorder is stopped, press the ASSIGN button to open the INPUTASSIGN screen. By default the recording sources are assigned to the tracks asshown below.Recording track Recording source Default valueTRACK 1 INPUT A IN ATRACK 2 INPUT B IN BTRACK 3 INPUT A/B IN A-BTRACK 4 INPUT A/B IN A-BSince you set internal MIC A as the input source for INPUT A and internal MICB as the input source for INPUT B on the INPUT SETTINGscreen in theprevious “Setting the internal mics as input sources” section, signals from MICA and MIC B will be recorded to TRACK 3.So, in this example, you do not need to change the input source assignmentsettings to use the internal mics to record the rhythm guitar to TRACK 3.
