Tascam MD-CD1mkII Owner's Manual

Contents

30 TASCAM MD-CD1MKIIIPitch control (CD only)When playing back an audio CD, the pitch (or speed) ofthe playback can be varied. Pitch can be varied –50% to+16% for CD.NOTEPitch control does not function for data CDs.Front panel operation1 During stop, playback or playback standby mode,press the PITCH control to turn the Pitch Controlfunction on.2 Rotate the PITCH control knob to set the pitch.NOTEUse the PITCH STEP? option in the PLAY sub-menu ofthe CD menu to adjust the pitch control steps from 0.1%to 1.0% in 0.1% increments. (Default: 0.1%)Remote control operation1 During stop, playback or playback standby mode,press the PITCH button to turn the Pitch Controlfunction on.2 Use the PITCH –/+ button to set the pitch.Pitch is adjusted in 0.1% increments.NOTEPitch control only functions during normal playback.•During recording, pitch control does not function.When turning the pitch control on and off during•playback, sound output is cut for a short instant.Single-track playbackThis function enables playback of just a single track.During stop mode, press the P. MODE button onthe remote control, and SINGLE lights up in thedisplay.Stops playback after playback of a track has finished.NOTEIf the Repeat function is also on, the selected track will•be played repeatedly.You can also use the• PLAY MODE? option in thePLAY sub-menu of the MD and CD menus to set theSingle track playback mode.Even when the power is turned off, the Single-track•playback mode settings are retained.Program playbackThis function enables playback of selected tracks in anydesired order. Up to 99 tracks can be selected from a CD,or up to 25 tracks from an MD, for Program playback.Programs of up to 100 discs including CD and MD can beretained.1 During stop mode, press the P. MODE button onthe remote control until PROGRAM is indicated onthe display.The program number and total program playingtime will be shown on the character display. Thehighest program number among the currentlyregistered programs appears on the programnumber display immediately after the mode ischanged.0p 0m 0sProgram numberTotal program playing timeNOTEYou can also use the• PLAY MODE? option in thePLAY sub-menu of the MD and CD menus to set theProgram Playback mode.The total program playing time does not appear for•data CDs.Before setting up a program, press the• STOP (ª)button to enter stopped status.2 Use the number buttons on the remote control toselect each desired track for program playback,then press the ENT/YES button.The track number will be entered into the program.NOTETo set the program by front panel operation, use theMULTI JOG dial to select the track number, then press thedial to add the track to the program.3 Repeat the above step 2 until the desired programis completed.As the program is being created, the program numberand total program playing time is revised on thedisplay.To confirm program contents, press the skip buttonsduring playback or playback standby.NOTEIf the total program playing time exceeds 999 min 59 sec,“- - - m - - s” is displayed.4 When program setting is completed, press thePLAY button to begin playback of the tracks in theprogrammed order.7 – CD and MD Playback