100 Commissioning WAGO-I/O-SYSTEM 750750-666/000-003 4FDI/2FDO 24V/10A PROFIsafe V2 iParManualVersion 1.2.0, valid from HW/SW Version 01/017.4.4.5 Direct Start from the Configuration Program (Module Level TCIConformance Class 3)In the configuration program of the safe PLC, select a module (PROFIsafe I/Omodule) and from the "WAGO-Safety-Editor 75x" TCI link, start the WAGO-Safety-Editor 75x. The configuration program passes the current language andcommunication setting to the Safety Editor. The Safety Editor is started inONLINE mode.Communication occurs over the PROFIBUS fieldbus for a PROFIBUS fieldbuscoupler.Variants are not supported for PROFINET!This call option is not supported for PROFINET!7.4.4.6 Direct Start from the Configuration Program (Device Level TCIConformance Class 3 OFFLINE)In the configuration program of the safe PLC, select a device (fieldbus coupler)and from the "WAGO-Safety-Editor 75x" (offline) TCI link, start the WAGO-Safety-Editor 75x. The configuration program passes the current language settingto the Safety Editor. The Safety Editor is started in OFFLINE mode.7.4.4.7 Direct Start from the Configuration Program (Module Level TCIConformance Class 3 OFFLINE)In the configuration program of the safe PLC, select a module (PROFIsafe I/Omodule) and from the "WAGO-Safety-Editor 75x" (offline) TCI link, start theWAGO-Safety-Editor 75x. The configuration program passes the currentlanguage setting to the Safety Editor. The Safety Editor is started in OFFLINEmode.