WAGO-I/O-SYSTEM 750 Notes about this Documentation 7750-666/000-003 4FDI/2FDO 24V/10A PROFIsafe V2 iParManualVersion 1.2.0, valid from HW/SW Version 01/011 Notes about this DocumentationKeep this documentation!The operating instructions are part of the product and shall be kept for the entirelifetime of the device. They shall be transferred to each subsequent owner or userof the device. Care must also be taken to ensure that any supplement to theseinstructions are included, if applicable.Technical Terms in this DocumentationThe technical terms used in this documentation are available in the glossary at theend of the manual.1.1 Validity of this DocumentationThis documentation is only applicable to the I/O module 750-666/000-003(4FDI/2FDO 24V/10A PROFIsafe V2 iPar) of the WAGO-I/O-SYSTEM 750series from HW/SW Version 01/01.The I/O module 750-666/000-003 shall only be installed and operated accordingto the instructions in this manual and in the manual for the used fieldbuscoupler/controller.Consider power layout of the WAGO-I/O-SYSTEM 750!In addition to these operating instructions, you will also need the manual for theused fieldbus coupler/controller, which can be downloaded at www.wago.com.There, you can obtain important information including information on electricalisolation, system power and supply specifications.Observe the information on the power infeed concept!Detailed information and examples for supplying PROFIsafe I/O modules isavailable in the section "Power Infeed Concept".1.2 CopyrightThis Manual, including all figures and illustrations, is copyright-protected. Anyfurther use of this Manual by third parties that violate pertinent copyrightprovisions is prohibited. Reproduction, translation, electronic and phototechnicalfiling/archiving (e.g., photocopying) as well as any amendments require thewritten consent of WAGO Kontakttechnik GmbH & Co. KG, Minden, Germany.Non-observance will involve the right to assert damage claims.