Operation RD 12A28 wc_tx001071gb.fm4.6 Roll Over Protection Structure (ROPS)The machine is equipped with a Roll Over Protection Structure(ROPS). The machine is normally delivered to the customer with theROPS folded forward to facilitate transport.Do not use the machine without the ROPS in place. The ROPS isdesigned to protect the operator in a rollover accident.Before using the machine, position the ROPS in the fully uprightposition as follows:4.6.1 Support the ROPS using a crane and suitable rigging capable ofsupporting 43 kg (95 lbs.).NOTICE: Do not use the ROPS to lift the machine.4.6.2 Remove the shipping strap from both sides of the frame. Save thewashers.4.6.3 Loosen the bottom mounting bolt on both sides.4.6.4 Rotate the ROPS into the upright position.4.6.5 Secure the ROPS to the frame using the saved washers and thesupplied bolts. Torque hardware to 106 Nm (78 ft.lbs.).Each month, check the torque on all of the screws holding the ROPSin place. Check that the ROPS frame is not rusty, cracked, broken, ordamaged in any way.Change the seat belts every 3 years, or any time they have beensubjected to accident-level loads.If the ROPS has been removed from the machine, it must bereinstalled before the machine is used. When reinstalling the ROPS,use the original nuts and bolts and tighten the bolts to the specifiedtorques.Do not weld or drill into the ROPS. Drilling or welding on the ROPS willnullify the ROPS certification.WARNING