RD 12A Operationwc_tx001071gb.fm 414.19 Stopping/ParkingSee Graphic: wc_gr0029534.19.1 Stop the machine on a flat surface with a suitable load bearingcapacity.4.19.2 Turn the vibration off by pressing the vibration control button (10) onthe forward/reverse lever (15).4.19.3 Press the water spray switch to the OFF position (61).4.19.4 Set the forward/reverse control (15) to the NEUTRAL position.4.19.5 Return the engine throttle to idle by pressing the lower half of thethrottle switch (54) and allow the engine to cool down.4.19.6 Set the parking brake (42). To set the parking brake, pull the brakelever up until the brake pad engages the drum. To release the brake,lower the brake lever. Always set the parking brake before leaving themachine.Note: The parking brake engages the rear drum only.4.19.7 Stop the engine by turning the ignition switch (55) to the OFF position.If the vehicle constitutes a hazard or obstacle to traffic when parked, itshould be marked with signs, lights, and other warnings.If the machine must be parked on a sloping surface, chock the drumswith wedges to prevent any vehicle movement.WARNINGwc_gr002953NF R614210155554
