Walker H24d Operator's Manual

Also see for H24d: Operator's manual

H24d Assembly Instructions21Deck Discharge Deflector Shield Installation(DS61)Attach the side discharge deflector shield usingtwo (2) 3/8-16 x 1-1/4 in. bolts, 3/8-16 ESNA nuts,and 3/8 in. wave spring washers. The wave wash-ers fit between the two hinging surfaces. Tightenthe nuts until the shield moves freely but is notloose.WARNINGDO NOT operate the machine without thegrass deflector shield attached and in thelowest possible position.Attach ShieldDeck Discharge Shield InstallationPTO Shaft Guard InstallationPosition the shaft guard as shown and mount withtwo (2) 1/4-20 x 1/2 in. bolts.AttachGuardCarrier FrameTube SocketsPTO Shaft Guard InstallationTilt-Up Roller Wheel InstallationMount the two (2) tilt-up roller wheels on the brack-ets on the rear skirt of the deck housing using theaxle spacer tube, 3/8-16 x 3-1/4 in. bolt, and 3/8-16Whiz locknut. Tighten the bolt until the wheel rollsfreely, but is not loose.RollerWheelsRoller Wheel Installation (Typical DS61 Shown)Mower Deck Installation on TractorDeck Installation1. Lightly grease each deck support arm (2) onthe tractor. Refer to Mower Deck Installationphoto for location of deck support arm.