28 Getting to know the WIDE FORMAT COPY SYSTEM Xerox 6030/6050 Wide Format Copy SystemPowering On the Xerox 6030/6050Wide Format System with ScanSystemTo power on the Xerox 6030/6050 Wide Format System with ScanSystem you first must switch on the SCAN SYSTEM and wait for 30seconds or check that a P is displayed on the status LED in the back ofthe SCAN SYSTEM. Then switch on the Xerox 6030/6050 Wide Format,then the AccXES Print Server.When the SCAN SYSTEM is present, the DDS parameter must be set toEnabled in order to enable the COPY/SCAN functionality. If the DDSparameter is set to Disabled, COPY/SCAN functionality will not beenabled.The default for the DDS parameter is disabled. You must ensure that itis set to Enabled when powering on the XEROX WIDE FORMAT SCANSYSTEM for the first time. For the Xerox 6030/6050 Wide Format youcan set the DDS parameter from the PRINTER SETUP/Miscellaneousscreen of the Web PMT. Refer to the WebPMT Printer Manager ToolUser Guide for more information. After setting the DDS parameter, wait30 seconds, and then power the system off then on. Once you enablethis parameter, it will remain enabled (even following future softwareupgrades).To switch on the Scan System, press the Power On/Off Switch on theback of the Scan System to the On (I) position as shown below. Wait for30 seconds or until a P is displayed on the status LED.SCAN SYSTEMPower Switch
