72 Special features keys DocuWide 6030/60507. Enter the number of copies desired and press the Start key.The Printer prints the number of sets requested.NOTE: In COLLATION FORWARD only, an extra set is made as a checkplots set.After the printing of the set, the set can be recalled, the values changedagain, and the set reprinted using the new values. To recall the set, referto "Store/Recall key" in the "Special features key" section of this manualfor further information.Batch keyThe Batch feature allows you to improve copy speed by enabling BatchMode processing of several documents on the SCAN SYSTEM. WhenBatch Mode processing is enabled, the SCAN SYSTEM collects prescaninformation for just the first document inserted into the SCAN SYSTEM.Prescan information on subsequent documents in the set is notcollected. The subsequent documents will be scanned using theinformation collected on the first document. Eliminating the collection ofthis information increases overall copy speed.To enable Batch Mode processing:1. Press the Batch key. The Batch indicator lamp will beginflashing.2. Insert the first original into the SCAN SYSTEM. The SCANSYSTEM scans the original and the screen shown below isdisplayed.WIDTH FOUND FOR SET IS XX.XINPUT ANOTHER WIDTH ORPRESS ENTER TO ACCEPT3. Do one of the following:Use the numeric keypad to enter the width of the set and press the Enterkey to accept the value.Press the Enter key to accept the width detected by the WIDE FORMATCOPY SYSTEM.The Batch indicator lamp becomes steady and remains so until batchmode is disabled.4. When the last document in the set has been scanned, press theBatch key to disable batch mode. The Batch indicator lamp isextinguished.NOTE: When Batch mode is ENABLED, the AUTOCENTER feature istemporarily disabled. Be careful to manually center each document thatis inserted into the SCAN SYSTEM
